Car Coatings

7660 “Polish” Plastics & Metal 2-in-1

Emulsion for surface modification of nonabsorbent substrates (lacquer, metal, polymers)

Unlike our standard coating this 7660 SiO²-based polish is an emulsion. The coating is very easy to apply and it withstands high levels of soiling and abrasion. Simply wipe on and buff off. This polish contains particles that are much smaller than a regular polish, thus enabling it penetrate deeper into the structure of the surface.

Characteristics

  • Milky emulsion (“viscous, yellowish liquid”)
  • Solvent and aromatics free, pH-neutral
  • Frost resistant
  • Can be applied in temp. range -25 °C to +80 °C
  • UV-resistant
  • Easy-to-clean properties
  • Water and oil repellent
  • 25-50 m² per liter

Downloads

Application

7660 “Polish” Plastics & Metal 2 in 1 is ready to use. The amount to be applied (20 to 40 ml /m²) depends on how “absorbent” the substrate is and should be tested in advance. 7660 “Polish” Plastics & Metal 2-in-1 cleans, polishes and coats in one pass. The surfaces to be treated should be clean and dry before treatment!

7660 “Polish” Plastics & Metal 2 in 1 can be applied by hand, through polishing with a soft pad (or soft cotton cloth, sponge etc.) which has been impregnated with the formulation, or by machine (polishing/eccentric machine etc.), using a soft polishing pad.

Apply 7660 “Polish” Plastics & Metal 2 in 1 and work it onto/into the surface until it has vanished. Excessive material can be removed with a clean dry pad. Hydrophobicity immediately appears upon treatment and the phenomenon will increase further over the following minutes. Complete cross linking will take up to 1 hour depending on temperature. The process will be continued long after the treated area has become visibly dry.

During application the outside temperature and the temperature of the substrate should be within the range of -25 °C to +80 °C.